Uh oh! 3D printed objects found to be toxic to fish

by | Nov 20, 2015 | Advanced Aquarist | 0 comments


Uh oh!  3D printed objects found to be toxic to fish


Embryo development on 3D printed disks.

3D printing is an increasingly popular method of producing custom parts for a wide range of applications.  This technology has been utilized by aquarists to print objects such as frag plugs to replacement/modified pump parts.

However, a new research should make us pause and rethink the safety of 3D printing.

Researchers at the University of California at Riverside placed zebrafish embryos on disks created from the two main techniques used in 3D printing: stereolithography (STL) and fused deposition modeling (FDM).  The results are alarming.

Embryos exposed to both types of 3D printing techniques were severely harmed.  While both resulted in mortalities and deformities, FDM-printed plastic was found to be significantly less toxic than stereolithography.  In fact, embryos placed on STL disks had almost a 100% mortality rate, with the few that survived all developing grotesques deformities.

Stereolithography is a 3D printing technique in which plastic is built up by layering resins that harder when exposed to light.  The researchers hypothesized that the resins had not fully cured and may be leeching toxic chemicals that harm the fish, so to test this theory, they irradiated STL disks to UV light in an attempt to further cure the resins.  Sure enough, disks exposed to UV light were found to be much less toxic, although mortalities and deformities still occurred (at a much lower rate).

Note: The researchers have not yet identified what chemicals in 3D printed plastics are toxic to fish nor at what concentration they are toxic.  The embryos were placed in direct contact with the 3D printed disks, so proximity must be factored into the interpretation of the results.  Also, 3D printers use a wide range of chemicals, so we do not know what 3D printed plastics are toxic.

In light of these findings, we may want to reevaluate the safety of using 3D printing in aquariums.  Further curing of 3D printing objects with UV light (or sunlight) may alleviate any toxic leeching.


Journal Reference:

Shirin Mesbah Oskui, et al.  Assessing and Reducing the Toxicity of 3D-Printed Parts (2015).  Environmental Science & Technology Letters.   DOI: 10.1021/acs.estlett.5b00249

  • Leonard Ho

    I'm a passionate aquarist of over 30 years, a coral reef lover, and the blog editor for Advanced Aquarist. While aquarium gadgets interest me, it's really livestock (especially fish), artistry of aquariums, and "method behind the madness" processes that captivate my attention.

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *

Upcoming Events