It is one of the most tedious tasks of
reefkeeping and yet in some respects a satisfying one. A freshly scrubbed front glass can
transform the appearance of a reef tank and make all the hard work involved in maintenance
seem worthwhile. There’s nothing like cleaning the front glass, sitting back and
realizing that the tank looks better than you remembered.
It seems that every hobbyist develops his or her own preferred cleaning
regimen. Some hobbyists favor razorblades while others favor plastic scrapers. The problem
with these methods is that it invariably involves getting wet. For a small tank it may
mean just getting one’s hands wet, but for a large tank, cleaning the glass with a
scraper generally means sticking much of one’s arm into the tank. While some
hobbyists look forward to sticking their arms in the tank, others prefer to keep dry. For
these folks the cleaning magnet is the solution.
A selection of cleaning magnets. Photo: Richard
Harker.
A cleaning magnet consists of a pair of magnets encased in two blocks of plastic. One
block has a soft pad attached to it while the other has an abrasive pad attached. The
abrasive side is placed on the inside of the glass while the soft side is placed on the
outside. Because of the magnets, the two sides (theoretically) stay together. Pulling the
outside part along the glass pulls the abrasive side along the inside and the algae is
scrapped off.
The process is simple and nearly fool-proof
in small freshwater tanks. However, reefkeeping presents a much greater challenge for
algae cleaning magnets. Like an arms race where escalation on one side is met by
escalation on the other, the rapid development of larger reef tanks has created the
pressure to produce more powerful cleaning magnets that work with larger tanks and thicker
glass. The cleaning magnets of the past used weak magnets that could remove a thin coating
of hair algae on thin glass, but not much else. Used on a reef tank, one generally ends up
still having to stick one’s arm in the water either to use a razor-blade to remove
coralline algae, or to retrieve the magnet from the bottom of the tank because of too
vigorous scraping.
The situation began to improve in the 1990s. A Dutch
company began producing the Algen Magneet, a much more powerful algae cleaning magnet.
Larger and heavier than the magnets then available, it performed much more reliably in
large tanks with glass thicker than one-half inch. While more powerful than typical
cleaning magnets, the Algen Magneet can barely stay attached to tanks with one inch glass.
The next powerful magnet to hit the hobby was made in Germany by Tunze. The magnets were
much stronger than even the Algen Magneet, but like anything else made by Tunze and sold
in the United States, the magnets were also much more expensive. Despite the high price,
hobbyists with larger tanks started buying the Tunze magnets because they worked. Finally
in 1998 a U.S. company began making algae cleaning magnets even more powerful in the
Tunze. Today we find several companies selling a wide range of powerful cleaning magnets
for reef tanks with up to 1½ inch glass.
Proud sponsor of this column
One may not think of Madison,
Wisconsin as the epicenter of algae cleaning rare-earth magnets, but Madison is the home
of two magnetic algae cleaner producers. Both Magnavore and Algae Free are based in
Madison and both sell an extensive line of cleaning magnets. That’s one irony of the
escalation of algae cleaning magnets. The hobby has gone from one or two choices to a
somewhat confusing array of choices in just a few years. Both companies sell
"rare-earth" magnet based cleaners. The rare earth reference is to Neodymium, or
more accurately a compound called NIB, for Neodymium Iron Boron (Nd2Fe14B).
For many years I used the Algen Magneet with
my 300 gallon 3/4 inch glass reef tank. If I wasn’t too vigorous in my cleaning, the
two parts generally held together. Too often I still needed to get in the water to scrape
bits of coralline algae off the glass and the last bits always seemed to appear in the
hardest to reach portions of the glass. When I moved everything to my larger tank with 1
inch glass I knew that the Algen Magneet would not be strong enough. Using their web
sites, www.aquariumcleaner.com and www.magnavore.com . I ordered the magnets
recommended for 1 inch glass. Both companies delivered the magnets within a few days.
Comparing the magnets of the two companies is somewhat
complicated by the fact that there is no standard for comparison and the two product lines
are somewhat different. Does one compare two magnets comparably priced, or two sized for
the same thickness of glass? The Magnavore for one inch glass is the Magnavore 8 and it
sells for $199. The Algae Eater for one inch glass is the Great White and it sells for
$170. The next smaller Magnavore is the Magnavore 6 which sells for $139, and it is
intended for 3/4 inch glass.
The standard unit of
magnetic strength is Gauss, a measure of magnetic flux density. Measuring Gauss would be
the most objective comparison, but what flux density is required to clean one inch glass?
This is a subjective decision, one the two companies apparently differ on because one
magnet is more powerful than the other. While the companies could publish flux densities,
one would still be left uncertain what flux density was needed for a particular tank.
Proud sponsor of this column
From personal experience it
seems that most products intended for the hobby are optimistically rated. If something is
intended for a 50 gallon tank, it has been my observation that in typical use the product
should be used in tanks smaller than 50 gallons. The magnets of Algae Free and Magnavore
may be one notable exception. Both companies’ magnets rated for one inch glass grip
with a great deal of force. It takes consider effort to slide the magnets across the
glass. As I stated earlier, the force needed to clean algae on a given thickness of glass
is a subjective decision. Therefore, one can only offer an opinion. In the view of this
hobbyist, the magnets are very conservatively rated. Hobbyists may be able to use a magnet
intended for slightly thinner glass.
Both magnets are well constructed. The
Magnavore is all plastic while the outside portion of the Algae Free magnet is finished in
wood. The Algae Free magnet comes in a plastic storage case while the Magnavore comes in a
cardboard storage case. Both use comparable materials for the abrasive pad. The Magnavore
8 is noticeably more powerful than the Algae Free Great White, but on the other hand, the
Great White is $30 less. I found the Algae Free magnet easier to work with since it is not
quite as powerful.
I attempted to measure the force needed to move the
magnets along the glass and could easily measure the difference between an Algen Magneet
and the two cleaners under discussion. However while I could feel a difference between the
Magnavore 8 and the Algae Free Great White, I couldn’t reliably measure the
difference.
Using an electronic scale to measure the
needed force, I pulled the magnets along the glass at a "constant" speed, noting
the read-out. The Magneet moved along smoothly at 2 pounds. Both the Magnavore 8 and the
Great White required approximately 8 pounds of force to move along the same section of
glass at the same speed. This is certainly a crude measurement, but hobbyists using an
inexpensive fish scale could do similar measurements on their own tank to compare magnets.
This is one example where the pooled resources of a hobbyist club could help members
compare different magnets.
Proud sponsor of this column
One new addition to the algae
cleaning options for hobbyists is the floating magnet. Since one of the problems of
magnets is their tendency to detach and fall to the bottom of the tank, a floating magnet
solves the problem. Algae Free now sells floating magnets while Magnavore does not, so if
floating is important, Algae Free may be a better choice, particularly if one chooses a
slightly undersized magnet.
One danger of using algae cleaner magnets is
the risk of scratching the tank. Small bits of coral and sand can work themselves into the
magnet’s abrasive surface and create fine scratches on the tank surface. This is
particularly true of softer acrylic tanks. Both companies provide special pads to be used
on acrylic tanks. Choosing a slightly under-rated magnet may also help in avoiding
scratches.
The most important caution regarding these
magnets is their force. Both magnets come with a very think piece of foam separating the
two sides. Should the two sides be accidentally brought together, the hobbyist will
probably not be able to separate them. If one’s fingers are between the two halves
when they snap together, serious injury is possible. If a hobbyist uses any of these
powerful magnets, be very careful while handling them. Also follow the instructions
carefully when attaching them to the tank. They need to be slid towards one another while
in contact with the glass. Just bringing them together on opposite sides of the glass
could break the glass from the force applied.
One other note regarding the magnets. Algae
magnets are useful for things other than cleaning algae. For example, I use magnets to
attach romaine lettuce to the glass. Suction cups can fail and float away, but attaching a
leaf of romaine with a magnet and then sliding it down the glass will keep one’s
hands dry and keep the lettuce in place longer than a suction cup. Other hobbyists have
glued powerheads to algae magnets. The magnets allow the hobbyist to move the powerhead as
needed and avoid using suction cups.
